Skip to content
Systematic Engineering (Pvt) Ltd
Power Utilisation

Stop paying for power the process never uses.

Most industrial plants run motors flat out and throw the surplus away in valves, dampers and slipping belts. Our power utilisation intervention fits variable speed drives where the load varies, and targets a reduction in power cost of up to forty percent.

Ask for a power assessmentSend your load details
The comparison plant owners ask for

Correction units against variable speed drives

Both appear on the same shortlist when a factory decides its power bill is too high. They do very different things, and only one of them changes what the plant actually consumes.

Power factor correction

Treats the demand, not the consumption

A capacitor bank supplies the reactive current the motors need, so the supply carries less current and the demand and penalty portion of the bill falls. Useful, and often worth doing. But the motor still turns at full speed whether the process needs it or not, so the units of energy you burn stay exactly where they were.

Variable speed drives

Matches the motor to the work in front of it

The drive varies motor speed to what the process actually calls for. On pumps and fans the power drawn falls far faster than the speed does, so trimming a fan or pump back to what the duty needs takes a large bite out of consumption rather than out of the tariff line. The drive also presents a high displacement power factor at its input, so a good part of what the capacitor bank was fitted to fix goes away with it.

Mechanical wear

Starting stops being an event

Direct on line starting slams full torque into belts, couplings, gearboxes and shafts, and pulls a starting current several times running current. A drive ramps the machine up under control, which lengthens the life of the driven equipment and takes the peak off your maximum demand.

Control

Process control you did not have before

Speed becomes a setting rather than a fixed fact of the machine. Feed rates, air volumes and flow can be tuned to the product instead of throttled down after the fact.

The intervention

How the saving is found and proved

We do not quote a percentage before we have measured your plant. The figure comes out of the load profile, and it is checked against the meter afterwards.

Current, voltage, power factor and running hours logged on the main drives, so the bill is broken down into machines rather than guessed at.

After it is fitted

The drive is intelligent enough to tell you what the plant is doing

A drive is a meter, a protection device and a condition monitor that happens to also run the motor. Most plants never read any of it. We set it up so you can.

What it reportsWhat you do with itWhere it shows
Power and energyLive kilowatts and accumulated energy per machine, so the power bill can be allocated to production.Drive display
Phase load reportingCurrent on each phase, imbalance and phase loss caught before it cooks a winding.Drive and alarm
Motor conditionThermal load, torque and current signature trending, which is where a failing bearing or a dragging machine shows up first.Trend log
Run hours and tripsService intervals set on actual running time, and a trip history that says why the line stopped at two in the morning.Fault log
Where it pays first

Conveyors, milling and crushing

These are the plants where a drive earns its keep twice: once on the power bill, and again on the clogging and stalling that costs a shift.

Conveyors

A loaded belt that has stopped will not restart across the line without slipping, snatching or tripping. The drive ramps it away under full load, limits torque so nothing tears, and can inch or reverse the belt to clear a build up.

Milling

Feed rate is matched to what the mill can take, so it is neither starved nor choked. Rising current tells you a choke is coming before the mill is packed and someone has to dig it out by hand.

Crushing

Controlled starting against a loaded chamber, torque limiting to protect the drive train on tramp material, and speed set to the product rather than to whatever the motor happens to run at.

Find out what your plant is actually spending.

We measure first. The saving is quoted from your own figures.