Six disciplines under one roof.
Most plant failures cross a boundary. A hydraulic press stops because of a control fault. A line stops because the air is wet. We work across the whole chain rather than handing you back to another contractor halfway through.
The disciplines we work in
Electrical power systems
Getting supply to the machine safely, switching it correctly, and protecting what sits behind it.
- Power distribution systems
- Backup power solutions
- Industrial and domestic installations
- Maintenance and fault diagnosis
Solar power solutions
Generation on site for homes, farms and plant that cannot afford to sit idle when the grid goes down.
- Solar system design and installation
- Hybrid systems: solar, grid and generator
- Solar water pumping systems
- Generators, repairs and maintenance
Hydraulic systems
Systems that move heavy load with fluid pressure, and the leaks, pressure losses and seized components that stop them.
- Hydraulic system design and installation
- Pump systems and fluid power solutions
- Cylinder, ram and seal replacement
- Maintenance and repairs
Pneumatic systems
Compressed air as a working tool, from the compressor house through to the actuator on the machine.
- Compressed air systems
- Pneumatic control systems
- Supply of new compressors
- Repairs and maintenance on all types
Industrial automation and electronics
Board level and system level work on the controls that decide what a machine actually does.
- Plant and machine automation
- Machine controller repair and supply
- Drive and inverter fault finding
- Sensor, instrument and obsolete part work
General engineering
The fabrication, fitting and mechanical work that has to happen around the automation for any of it to hold.
- Manufacture and refurbishment of processing plants
- Brackets, guards, frames and machine mounting
- Drive, coupling and bearing work
- Site installation and rigging support
The discipline that pays for itself
Variable speed drives sit across all of the above. They cut the energy a motor draws, report what the plant is doing phase by phase, and let a loaded conveyor or mill start without stalling.
From the first call to the machine running
The same four steps whether it is one controller or a full line retrofit. You always know which one you are in.
You tell us what has stopped or what you want built. We attend site, or take in the unit, and establish what is actually wrong.
You get the fault, the options, the parts and the cost, including where a repair is worth it and where it is not.
Work is carried out on site or in the workshop, with the plant shutdown planned around your production where it can be.
The system is run under load, set up, tested and handed to your operators, with what they need to keep it running.
Not sure which discipline your problem sits in?
That is our job. Describe the symptom and we will work back to the cause.